Introduction to CIPTrolley ™
Utilising standard pre-approved modules, the CIPTrolley™ is an entry level Cleaning In Place or Washing/Wetting In Place system that offers an economic solution to CIP whilst maintaining the quality of build and operation that Suncombe clients expect. The system is built from a selection of modules, allowing configuration of the system that you require whilst also affording full future proofing by either exchanging or adding modules at any time.
Customised as Standard
The CIPTrolley™ can be supplied with one, two or three stainless steel sanitary tanks up to 200 litre capacity to store chemical solution, cold or hot water and drainage. These solutions would be delivered in a controlled manner to the equipment to be cleaned at the required flowrate and pressure, to provide a Clean In Place of your equipment.
Static and Mobile Tanks and Vessels, Processors and Fermenters, Isolators, Mixers and Blenders, Labscale and Pilot scale plant, Dryers, Granulators, Coaters, Filters, Presses and Mills. Isolators, IBC’s, Pasteurisers, Homogenisers, Conveyors, Ovens, Ducting, Filters, Pumps, Dryers, Fillers Fillers and Whippers, Other Processing Equipment.
Cold Water Rinse, Cold Detergent Rinse, Hot Water Rinse, Hot Detergent Rinse, Cold Sanitiser Rinse, Air Purge, Drying
Typical Manufacturing Standards
• Sanitary Construction, fully drainable, crevice free.
• 316 stainless steel contact parts, 304 non-contact parts, T.I.G. Welding
• 316 Stainless Steel pipework
• Sanitary Centrifugal Pump
• Sanitary Valves, manual and air operated
• Steam heating
• Calibrated Instruments